Annotate
Annotations can be attached to points of interest and consist of a unique name, a description and a list of hyperlinks. Annotations created in the Scan View are shown in all views, also in the Panorama View of other scans.
Select the task Annotate from the Task Panel.
The yellow color states that at least one mandatory step is not finished. As soon as you enter valid data, the color will change to green.
1. Select Position: Select the position in the Panorama View where the annotation should be created. The xyz coordinate of the selected point will be displayed in the task.
You can also add an annotation to an area. For this, click the Select Area button.Then, start picking the points for this area. After picking the third point, the check-box Connect end points appears. Uncheck it if the points shall not be used for an area but for a distance line.
Note: Area annotations created in the Scan View are shown in all views, also in the Panorama View of other scans.
2. Set Color: only available for selected areas. Select a color for the annotation line using the following methods:
Color field with 16 predefined colors.
Advanced color picker of the browser: click the colored field to open it.
Text input field for the color's RGB hex color code, for example, #ffffff for white, #000000 for black and #ff0000 for red.
3. Enter Name: Enter the new name of the object. The name may contain any character you like.
4. Enter Description (optional): Enter the description of the object. Format your entries by using some simple tags. Click the link to learn about the formatting syntax. For example, starting a line with the # character will format this line as a heading
5. Add links (optional): You may add links to files stored at 3rd party providers or to any other web page.
6. Set Category: Click None, if the object shall not belong to a category or enter a new category name in the New Tag field and click Set.
7. Set Tags: Select, if this object should be assigned to a tag or enter a new tag name in the New Tag field and click Set.
8. Click OK in the task description to save the changes.
To delete the object, use the task Delete.